CT803

  1. Home
  2. Products
  3. Accessories
  4. CT803
csm_MC800_R_55598d21f7.png

CT803-Firmware: Rotating Cross Cutters

in combination with Motion Controller MC800

The MC800 multi-axis motion controller, a successor to the proven MC700, impresses with its even higher bandwidth and an even more flexible bus architecture. Universal encoder inputs allow the connection of various encoder and sensor systems. A special feature of this drive control is the integrated tandem drive controller, which enables the acceleration demand of a following axis to be achieved by power distribution on two independent drives.

For machines such as rotary cross-cutters or other rotary applications, the CT803 firmware, together with the MC800 hardware, scores with its short position control cycles, high dynamics and precise cuts.

Technical data

  • 2 pulse inputs with format  A, /A, B, /B, Z, /Z [HTL, RS422]
  • with an input frequency up to 2 MHz
  • 2 control inputs with format  SIN+, SIN-, COS+, COS- [1 Vss] with an input frequency up to 400 kHz
  • 2 SSI inputs with format  DATA+, DATA-, CLOCK+, CLOCK- up to 25 Bit, with SSI switching frequency of 100 Hz ... 1 MHz
  • 2 scalable 14 bit analog inputs for ±10 V or 0/4 ... 20 mA
  • 4 control inputs for PNP / NPN signals [10 ... 30 VDC]
  • 4 fast interrupt inputs for PNP / NPN signals [10 ... 30 VDC]
  • 1 pulse output with format  A, /A, B, /B, Z, /Z [RS422]
  • 4 control outputs with push-pull characteristic, short-circuit-proof [5 ... 30 VDC]
  • 2 scalable 14 bit analog outputs for ±10 V or 0/4 ... 20 mA
  • Loop time approx. 250 µs
  • Power supply 18 ... 35 VDC
  • Snap-on housing for top hat rail (according to EN 60715)
  • OnBoard interfaces: Ethernet / IP, RS232 / RS485, USB 2.0, CANopen, Modbus RTU
  • Optional Ethernet interfaces: EtherCAT, Ethernet / IP, Modbus TCP, Powerlink, PROFINET, SERCOS III
  • Optional Fieldbus interfaces (slave): CC-Link, DeviceNet, PROFIBUS
  • Operates with all 4-Q-drive systems, equipped with a standardized drive communication bus (e. g. SERCOS-II). Alternatively ±10 V setpoint can be used
  • The controllers can be setup by an external operator terminal as well as HMI’s via standardized factory communication bus e. g. PROFINET
  • Setup via windows operator software (free of charge)

Additional Product Information